MOLTA vessel

Instructions for Use – Planters with a Rotatable Insert 1. Tall and Low Planters

• Tall planter – requires filling with ballast (e.g. gravel, expanded clay) through the large filling hole.
  • It should not be used without ballast.
  • Once filled, the hole must be sealed with the stopper.
• Low planter – can be used without additional ballast. It is also fitted with a large filling hole and stopper.

  2. Stoppers – Filling and Drainage The planter is fitted with two openings and two stoppers:

• Large filling hole – used for adding ballast to stabilise the planter. Simply remove the stopper, fill with material, and replace the stopper. There is no need to turn the planter upside down.
• Small drainage hole – allows excess water to drain from the insert. This hole is factory-drilled.
  • It can be kept closed or open depending on where the planter is used.
  • The stopper for this hole is stored in a dedicated compartment inside the planter.

3. Preparing the Rotatable Insert (Fixed Insert Version) Drill a hole in the designated spot to allow water to drain freely into the base of the planter. 4. Using the Planter in Different Settings

• Indoor use (e.g. at home) – close the small drainage stopper to prevent water leaking onto the floor (e.g. panels, parquet).
• Outdoor use (garden, lawn) – there is no need to close the drainage stopper; water can flow out freely and soak into the ground.
• Balcony or terrace use – it is recommended to close the small drainage stopper to avoid water spilling onto the surface.